Mixture biocide of MIT and BIT for cosmetics application
Mixture biocide of MIT and BIT for cosmetics
Product name:MB5 Biocide
CAS: 2634-33-5; 2682-20-4;
Composition:MIT and BIT (Methylisothiazolinone; Benzisothiazolinone;)
Same effect as product of Thor’s product of Microcare SI; Innoman MB;
Our factory professcial product the MB 5 biocide, whichis is an aqueous solution of BIT (1,2-Benzisothiazolin-3-one) and MIT(2-Methyl-4-isothiazolin-3-one) at a ratio of 1:1; The MB 5 biocide combines the well proven active ingredients BIT and MIT which can provide a long-term and broad efficacy spectrum, widely used for the in-can preservation of technical products..
MB5 biocide is a VOC- and AOX-free preparation. It is formulated without the addition of any organic solvents, halogenated organic compounds, formaldehyde releasing compounds or bivalent metal ions, and therefore, it is highly compatible in most binder and paint systems.
Composition: (Chemical characterization: Mixtures )
CAS NO. | Mixtures Component | Weight |
2634-33-5 | 1,2-Benzisothiazolin-3-one | 2.0-3.0% |
2682-20-4 | 2-methyl-4-isothiazolin-3-one | 2.0-3.0% |
7732-18-5 | Water | Balance |
Characteristics:
1) It is a new generation of synergistic type without CIT (5-chloro-2-methyl-4-isothiazolin-3-one), AOX (adsorbable organic halide) and VOC (organic volatile matter) Fungicide.
2) Wide applicable pH range, can be used in the range of 2.0 ~ 10.0.
3) Do not add any organic solvents, halogenated organic compounds, formaldehyde releasers or divalent metal ions.
4) It has a very broad-spectrum bactericidal activity against bacteria, molds and yeasts that cause pollution and degradation of aqueous products.
5) Easily soluble in water, most lower alcohols and glycols.
Usage and precautions:
1) It is recommended to use a concentration of 0.2-0.4%. Select the appropriate dosage according to the product used and the environmental conditions.
2) MB5 biocide should be noted that the temperature, pH value and redox potential during addition will not affect the stability of this product.
3) This product should avoid direct contact with eyes. Once in contact, rinse immediately with plenty of water without delay. Do not contact with skin for a long time
4) Store in the original container. Avoid extreme temperatures. Frost easily, BIT and BIT sodium salt may crystallize when the temperature is lower than 1℃; However, if it is heated to a maximum of 50℃, any crystals formed will dissolve again without affecting the performance.
Application:
MB-5 can be used to protect latex paints, polymer emulsions, adhesives, enamels, fillers, sealants and other water-based products from harmful microorganisms when they are wet, especially suitable for products with higher pH values and environmentally friendly formulas.
